产品标题：A-B-1794-IT8电源模块使用速度

型号： A-B-1794-IT8

质保：七天验收期，质保期一年

品牌：  A-B

产品图片展示

产品详情资料

设置系统时，请勿在基本单元上使用任何空插槽。如果有插槽

为空，请确保使用空白封面（AG60）或虚拟模块（AG62）。

使用扩展底座单元A52B、A55B或A58B时，将附带的防尘盖连接到插槽0中的模块。否则，模块的内部零件可能会

在短路试验中或意外发生过电流或过压时失效

应用于外部I/O部分。不要将控制线或通信电缆与主电缆一起安装

电路或电源线，或使它们彼此靠近。

它们之间保持100毫米（3.94英寸）或更大的距离。

否则可能会因噪音而导致故障。当输出模块用于控制灯负载、加热器、电磁阀时，

等，在

输出状态从OFF变为ON。采取一些预防措施，如

将输出模块更换为一个合适的额定电流CPU模块通电或复位至进入RUN时的时间

状态取决于系统配置、参数设置和程序大小。

设计程序，使整个系统始终安全运行，无论

当时的情况。

 产品实物图片展示

When setting up the system, do not allow any empty slot on the base unit. If any slot

is left empty, be sure to use a blank cover (AG60) or a dummy module (AG62) for it.

When using the extension base unit, A52B, A55B or A58B, attach the included dustproof cover to the module in slot 0. Otherwise, internal parts of the module may be

flied in the short circuit test or when an overcurrent or overvoltage is accidentally

applied to the external I/O section.Do not install the control lines or communication cables together with the main

circuit or power lines, or bring them close to each other.

Keep a distance of 100mm (3.94inch) or more between them.

Failure to do so may cause malfunctions due to noise.When an output module is used to control the lamp load, heater, solenoid valve,

etc., a large current (ten times larger than the normal one) may flow at the time that

the output status changes from OFF to ON. Take some preventive measures such

as replacing the output module with the one of a suitable current ratingTime from when the CPU module is powered on or is reset to when it enters in RUN

status depends on the system configuration, parameter settings, and program size.

Design the program so that the entire system will always operate safely, regardless

of the time.